+- Obi Official Forum (https://obi.virtualmethodstudio.com/forum)
+-- Forum: Obi Users Category (https://obi.virtualmethodstudio.com/forum/forum-1.html)
+--- Forum: Obi Softbody (https://obi.virtualmethodstudio.com/forum/forum-12.html)
+--- Thread: Stretching verts uniformly (/thread-4552.html)
Stretching verts uniformly - Aroosh - 13-09-2025
Hello
I have a softbody that looks like a block of iron which has about the same number of particles and vertices.
I noticed that when I stretch either of the sides the vertices do not stretch uniformly.
Can you point me in the right direction as to what parameters I should tweak in order to make this stretching uniform?
Thanks
Aroosh
RE: Stretching verts uniformly - josemendez - 15-09-2025
(13-09-2025, 05:32 AM)Aroosh Wrote: Hello
I have a softbody that looks like a block of iron which has about the same number of particles and vertices.
I noticed that when I stretch either of the sides the vertices do not stretch uniformly.
Can you point me in the right direction as to what parameters I should tweak in order to make this stretching uniform?
Thanks
Aroosh
Hi,
Use Parallel evaluation mode instead of Sequential. See:
https://obi.virtualmethodstudio.com/manual/7.1/obisolver.html#evaluationmode
kind regards,